Regarding Error Display (Sc-910/Sc-910A) - JUKI SC-910 Engineer's Manual

15. REGARDING ERROR DISPLAY (SC-910/SC-910A)

In case of the following, check again before you judge the case as trouble.
No. Phenomenon
1 When tilting the sewing machine, the When tilting the sewing machine
buzzer beeps and the sewing
machine cannot be operated.
2 Solenoids for thread trimming,
reverse feed, wiper, etc. fail to work.
Hand lamp does not light up.
3 Even when depressing the pedal
immediately after turning ON the
power, the sewing machine does not
run. When depressing the pedal after when changing spring pressure of
depressing the back part of pedal
once, the sewing machine runs.
4 The sewing machine does not stop
even when the pedal is returned to
its neutral position.
5 Stop position of the sewing machine
varies (irregular).
6 Presser foot does not go up even
when auto-lifter device is attached.
7 Touch-back switch fails to work.
8 UP position move fails to work when
all lamps on the panel light up.
9 Sewing machine fails to run.
Cause
without turning OFF the power
switch, Action given on the left side
is taken for safety sake.
When the fuse for solenoid power
protection has blown out
Neutral position of the pedal has
varied.
(Neutral position may be shifted
the pedal or the like.)
When tightening the screw in the
handwheel is forgotten at the time of
adjustment of needle stop position.
Auto-lifter function is OFF.
Pedal system is set to KFL system.
Cord of auto-lifter device is not
connected to connector (CN40).
Presser foot is going up by auto-liter
device.
Auto-lifter device is not attached.
However, auto-lifter function is ON.
The mode is in the function setting
mode.
The switch on the CTL p.c.b. is
pressed by the bound cords and the
aforementioned mode resulted.
Motor output cord (4P) is
disconnected.
Connector (CN38,CN39) of motor
signal cord is disconnected.
– 60 –
Corrective measure
Tilt the sewing machine after turning
OFF the power.
Check the fuse for solenoid power
protection.
Execute the automatic neutral
correction function of the pedal sensor.
Securely tighten the screw in the
handwheel.
Select "FL ON" by auto-lifter function
selection.
Change the jumper to PFL setting to
lift the presser foot by depressing the
back part of the pedal.
Connect the cord properly.
Operate the switch after the presser
foot lowered.
Select "FL OFF" when auto-lifter
device is not attached.
Remove the front cover, and arrange
the cords by the regular binding
procedure described in the Instruction
Manual.
Connect the cord properly.
Connect the cord properly.