Pro-face GP2500-TC41-24V Installation Manual page 10

Create a Panel Cut and insert the GP into the panel from the front
Unit: mm [in]
Panel
GP
Attach the Installation Fasteners from Inside the Panel
The following figures show the four(4) fastener insertion slot locations. Insert
each fastener's hook into the slot and tighten it with a screwdriver.
Panel
GP
• Tightening the screws with too much force can damage the GP's
plastic case.
• The necessary torque is 0.5 N•m.
• Depending on the installation panel's thickness, etc., the number of
installation fasteners used may need to be increased to provide the
desired level of moisture resistance.
6 Wiring
• To avoid an electric shock, when connecting the GP's power cord
terminals to the power terminal block, confirm that the GP's power
supply is completely turned OFF, via a breaker, or similar unit.
• The GP2500-TC41-24V/GP2600-TC41-24V units are designed to
use only DC24V input. Any other power level can damage both the
GP and the power supply.
• Since there is no power switch on the GP unit, be sure to attach a
breaker-type switch to its power cord.
+1 +0.04
301.5 [11.87 ]
0 0
Insertion Slots
Top
Installation
fastener
WARNINGS
Insertion Slots
Bottom