PSC Power Star Operation Manual page 10

TYPICAL 12Vdc POWER CABLES:
For use with PSC Solice Mixer, PSC M6 RetroMix, PSC RF MultiMax, PSC RF
Multi Dual 1x8, Cooper CS208, Audio Developments Mixers, and most other
audio mixers and recording devices that operate form 12Vdc and use a 4 pin
XLR power connector.
POWER STAR
4P MALE XLR
PIN 1-----------------------------------------------------------------------------PIN 1
PIN 4-----------------------------------------------------------------------------PIN 4
BATTERY POWER CABLES:
The cable used to connect the battery to your PSC Power Star is of special
importance as it carries the entire electrical load of your sound recording
package from the battery. In addition, it must carry the entire charge current to
the battery. This battery cable must be made from heavy gauge cable
(12AWG) and kept as short as possible to eliminate voltage drops across
the cable. Because you are working with a 12 volt DC system, the loss of even
1 volt across a cable run is unacceptable. We have equipped the PSC Power
Star with a Neutrik Speakon connector for connecting your battery.
connector is rated for use up to 30 amps. Each Power Star is supplied with a
Speakon to Speakon cable for use with your SLA batteries. We recommend that
you have all your cables professionally built or buy specially built cables made by
PSC from any authorized PSC dealer.
WARNING: It is highly recommended that you have your cables built by
qualified personnel and tested prior to use with your Power Star. All power
cables should be clearly labeled on both ends as to what they are to be
connected to. For example, label one end "Power Star" and the other end
"Solice Mixer". This will help prevent inadvertently connecting the cables
to the wrong piece of equipment. We cannot stress enough the importance
of good quality power cables and careful connections. Poorly constructed
and/or labeled cables can result in equipment damage!
SOLICE MIXER
4 PIN FEMALE XLR
This