Carrier CAPRI-280 Operation And Service Manual page 44

Logic Board, 1-3, 1-8
Low discharge pressure, 3-4
Low Pressure Shutdown, 3-2
low pressure switch, 1-4
Low Pressure Switch (LPS), 1-5
Low suction pressure, 3-4
Low Voltage, 3-2
M
Main Harness, 1-1
Maintenance Alarm 1, 3-3
Maintenance Alarm 2, 3-3
Maintenance Schedule, 4-1
Manifold Gauge Set, 4-2
Model 05G Compressor, 4-6
Monthly Inspection and Maintenance, 4-1
Motor Failure, 3-3
N
No Evaporator Air Flow Or Restricted Air Flow, 3-5
O
Oil Pump Method, 4-7
P
Parameter Codes
P2, Coil Temperature, 5
P20, Compressor Hours High, 5
P33, Kp, 6
Superheat, 5
Power Harness, 1-1
Power Relay, 1-1
pre---trip inspection, 1
Pressure Switches, 1-1, 1-5
Procedure for Evacuation and Dehydrating System ,
4-3
Program Memory, 3-1
Pumping The System Down, 4-2
INDEX
R
receiver, 1-2, 1-5
Receiver Tank, 1-2
Receiver Tank Support, 1-2
Refrigerant Leak Check, 4-2
Refrigeration Charge, 1-4
Refrigeration Cycle Diagram, 1-6
Refrigeration system, 3-4
Reheat/Cycle, 4-10
Relay Board, 1-1, 1-3, 1-7
Relays, 1-7
Removing The Refrigerant Charge, 4-2
Replacing Sensors and Transducers, 4-9
Restricted air flow, 3-4
Return Air Filter, 1-3
Return Air Probe Failure, 3-2
Right Front Grille, 1-2
Right Rear Lateral Grille, 1-2
S
Safety Devices, 1-4
Self Diagnostics, 3-1
Self-Test , 1
Service, 4-1
Service Valve, 1-2
Square Nut, 1-2, 1-3
Starting, 1
Stopping, 1
Suction and Discharge Pressure Transducer, 1-4
Suction And Discharge Service Valves, 4-1
Suction Line, 1-3
Suction Pressure, 3
Suction Pressure Transducer, 4-8
Suction Pressure Transducer Failure, 3-2
suction service valve, 1-4, 4-1
Superheat, 4-5
System Alarms, 3-1
system operation, 1
System Parameters, 5
System Pumpdown, 4-2
Index-3 T-283