Removing Discs; Writable Discs - Toshiba Satellite C50-A Series User Manual

Removing discs

To remove the disc, follow the steps as detailed below:
Do not press the eject button while the computer is accessing the optical
disc drive. Wait for the optical disc drive indicator to go out before you open
the disc tray. Also, if the disc is spinning when you open the disc tray, wait
for it to stop before you remove it.
1.
When the disc tray pops open slightly, wait a moment to make sure the
disc has stopped spinning before pulling the disc tray fully open.
2.
3.
How to remove disc when the disc tray will not open
Pressing the eject button will not open the disc tray when the computer
power is off. If the power is off, you can open the disc tray by inserting a
slender object (about 20 mm) such as a straightened paper clip into the
manual eject hole near the eject button.
1. Manual eject hole
Turn off the power before you use the manual eject hole. If the disc is
spinning when you open the disc tray, the disc could fly off the spindle and
cause injury.

Writable discs

This section describes the types of writable discs. Check the specifications
of your drive to see the types of discs it can write. Use TOSHIBA Disc
Creator to write compact discs.
CDs
User's Manual
To pop the disc tray partially open, press the eject button. Gently pull
the disc tray out until it is fully opened.
The disc extends slightly over the sides of the disc tray so you can
grasp it. Gently lift out the disc.
Push the center of the disc tray to close it. Press gently until it locks
into place.
Figure 4-4 Manual release with the manual eject hole
CD-R discs can be written only once. The recorded data cannot be
erased or changed.
Φ1.0mm
1
4-7