Minolta MACRO TWIN FLASH 2400 Instruction Manual page 4

Thank you for purchasing this Minolta product. Please read this
manual thoroughly before using the macro flash or ring flash. We
hope that you will continue to be satisfied by our products.
These products are designed and manufactured for use with
Minolta Maxxum/Dynax series cameras and some Minolta digital
cameras. Performance when used with cameras from other man-
ufacturers cannot be guaranteed. Minolta takes no responsibility
for accidents or malfunctions due to use with such cameras.
The AC Adapter for this Macro Flash Controller is available only in
Japan. The use of an AC Adapter other than the specified unit can
permanently damage the flash and cause heat or fire.
The information in this manual is relevant for products introduced
before February 2001. Contact the nearest authorized Minolta
Service Facility to obtain information for products released after
this date.
6
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Changes or modifications not approved by the party responsible for
compliance could void the user's authority to operate the equipment.
This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to
radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment to an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This Class B digital apparatus complies with Canadian ICES-003.
This mark certifies that these products meets the
requirements of the EU (European Union) concerning
interference causing equipment regulations. CE stands for
conformité Européenne (European conformity).
7