Attaching The Twin Flash - Minolta MACRO TWIN FLASH 2400 Instruction Manual

ATTACHING THE TWIN FLASH

1. Screw the appropriate adapter
ring onto the lens.
• 49mm and 55mm diameter adapters
are provided.
• If using the AF 200mm f/4 Macro Apo
G lens, a 72mm adapter is needed,
which can be be purchased sepa-
rately (p. 64).
2. While pressing the tabs on
both sides of the holder, place
the holder over the adapter,
then release both tabs.
3. Remove the protective socket
caps.
• For safe-kepping, place the cap(s) in
the case. Replace caps after use.
4. Place a twin flash unit into one
of the holder 's shoes.
• Use of an arm is also possible (p. 20).
18
5. Insert the twin-flash plug into
the twin-flash-cord socket on
the controller.
When removing the plug, press the twin-
flash-cord release button and pull plug
straight out of the socket.
• Do not remove the plug by pulling on the
cord.
6. Adjust position of flashtubes as
desired.
A twin flash unit can be attached to
any of the holder 's 4 shoes.
Flashtube can be tilted.
Holder can be rotated.
Press the release tabs
when removing or rotating
the holder.
Continued on next page 19