Lcd Display - Samsung SCX-4521F Series Service Manual

<continue..>
STATUS
BY PASS JAM
GROUP is not available
RETRY REDIAL?
NO. NOT ASSIGNED
Load document
Memory full and canel the job
Job has not been created
Low Heat Error
Open Fuser Error
Over Heat Error
Memory Dial Full
Samsung Electronics

LCD Display

[Bypass Jam]
Group Not Available
Retry Redial ?
NO. Not Assigned
Load Document
Cancel ?
1:Yes 2:No
Operation Not
Assigned
[Low Heat Error]
Open Fuser Error
[Over Heat]
[Jam 1]
[No Catridge]
Memory Dial Full
Descriptions
When the machine detected the non feeding from BYPASS Tray.
You have tried to select a group location where only a single
Location number can be used.
the machine is waiting for the programmed interval to automatically
redial a previously busy station.
The speed dial location you tried to use has no number assigned to it.
You have attempted to set up a sending operation with no
Document loaded.
When the machine has encountered the memory full during storing
the document into memory, the machine display the "CANCEL ?" to
operator whether he/she make a decision the canceling the job or
accept the scanned page so far to transmit the remained
documents.
When operator is doing in ADD/CANCEL operation and
There is no job to handle if operator entered the job no.
Temperature could not reach certain level.
The thermister has been disconnected.
Temperature has gone up very high degree.
When the machine detected the toner cartridge has not
been installed, or detected jam1 in warmup state.
During Auto dial transmission when all 15 jobs are configured and
try to add 16th job
Alignment and Adjustments
Service Manual
4-18