Led Status Error Messages - Samsung SCX-4521F Series Service Manual

Alignment and Adjustments
4.4 LCD Status Error Massages
STATUS
Document Jam
Door Open or Jam
Cover Open
NO paper
PAPER JAM 0
PAPER JAM 1
PAPER JAM 2
Communication Error
Line Error
NO ANSWER
INCOMPATIBLE
LINE BUSY
POWER FAILURE
STOP PRESSED
MEMORY FULL
FUSER ERROR
LSU ERROR
LSU ERROR
TONER LOW
TONER EMPTY
Service Manual
4-17
LCD Display
Document Jam
[Front or Rear]
[Cover Open]
[ No Paper ]
Add Paper
[Paper Jam 0]
Open/Close Door
[Paper Jam 1]
Open/Close Door
[Paper Jam 2]
Check Inside
[COMM. Error]
[Line Error]
[No Answer]
[Incompatible]
Line Busy
Power Failure
[Stop Pressed]
Memory Full
CRU Fuse Error
[Hsync Error]
[LSU Error]
[Toner Low]
[Toner Empty]
Descriptions
When Document Jam occurred at ADF module.
This is displayed on LCD, Print in the Transmission Journal.
When machine' front side cover or Jam Cover was opened, it
displayed On the LCD.
When there is no paper in CASSETTE Tray, machine Displays
this message on LCD.
When the machine encountered paper jam in pick up area,
Machine displays on the LCD until DOOR OPEN & CLOSE.
When the machine encountered paper jam in paper exit of Machine,
machine displays on the LCD until DOOR OPEN & CLOSE.
When the machine encountered paper jam in paper exit of Machine,
machine displays on the LCD until DOOR OPEN & CLOSE.
When the machine has problem in communication, It displayed on
the LCD.
Machine displays this in case of Transmission.
Machine displays this in case of fax handshaking step of Reception.
When the machine has problem in case of Fax Data reception step.
When the machine could not connect to remote fax after Completion
of redial up to redial counter in system data.
Remote party did not have the requested feature, such as polling.
The remote fax didn't answer.
When the machine's user memory has not been backup and There
was power off / on .
When the operator pressed the STOP button during transmission.
When the machine has encountered the user memory was full,
When the machine failed in installing the new toner cartridge.
tech mode
user mode
When the machine has encountered the Laser Beam Scanning unit
could not reach the READY state,
When the machine has encountered the Toner Low,
When the machine has encountered the Toner Empty,
Samsung Electronics