NOTE: A standard steering wheel puller and two 1/4–28
x 3 or 4 in. long screws are required to remove the clamp.
NOTE: Refer to Fig. 15.
1. Loosen the two screws (16) on the clamp (3), work-
ing through the slot at the bottom of the clutch hous-
ing (2).
2. Install two screws (B) of the tool (A) in two of the
threaded holes in the clamp (3). Tighten the screw
(C) until the clamp comes off.
3. Skip ahead to Reassembly, page 26, Step 3, or con-
tinue to the right.
NOTE: Refer to Fig. 16.
1. Remove the four capscrews (8) and lockwashers (9)
which hold the clutch housing (2) to the engine.
2. Remove the capscrew (15), lockwasher (80) and
washer (99) from beneath the mounting plate (D).
3. Remove the engine key (13).
4. Pull off the clutch housing (2).
5. Skip ahead to Reassembly, page 26, Step 1.
Clamp
A
B
C
Fig. 15
Clutch Housing
9
8
Fig. 16
2
13
2
D
99
80
15
3
16
0155
0156