Table of Contents
Advertisement
7.2.
Service Position
7.2.1.
Extension Cables for Service Position
Using the following Extension Cables, place the unit as shown for check and service.
Note:
1. The LCD open/close Switch is for changing between LCD Display and EVF Display. When turning on EVF Display, place some
paper or tape, etc. on LCD open/close Switch so that this Switch stays ON.
2. To eject the Mechanism, hold down the Eject Switch on the Rear Unit for a short time.
3. Use a grounded ESD wrist strap while disassembling the Lens portion.
4. Connect the F.P.C.s to the connectors, verifying the direction of F.P.C.s.
The Main P.C.B. or a Chip part will be especially damaged if the 90 Pin Extension Cable (LSUA0060) is misconnected.
5. Use extreme care when plugging or unplugging in connectors.
33
PV-GS29PL / PV-GS39PL / PV-GS69PL
Advertisement
Table of Contents
