Panasonic PV-GS29PL Service Manual page 58

PV-GS29PL / PV-GS39PL / PV-GS69PL
4. Removal of R Shaft Case Unit & LCD Ass'y
Take care not to damage the LCD open/close Switch.
1) Remove the 5 Screws (533, 537), and remove the R
Shaft Case Unit & LCD Ass'y.
Installation of R Shaft Case Unit & LCD Ass'y
1) Install the R Shaft Case Unit & LCD Ass'y so that the tab
is inserted into slot.
2) Tighten 5 Screws (533, 537).
537
tab
533
R Shaft Case Unit & LCD Ass'y
5. Installation of Lens Ass'y
Take care not to damage the motor leads.
1) Install the Lens Ass'y with the 3 bosses and 2 Screws
(537).
2) Connect the F.P.C.s to Connector FP701 and FP301,
then place the sheet on Connector FP301.
Lens Ass'y
Curve to the inside
537
FP701
537
537
LCD
open/close
533
Switch
Fig. D4
boss
537
sheet
boss
boss
FP301
Fig. D5
6. Installation of EVF Unit, Camera P.C.B.
Take care not to damage the EVF standby Switch.
1) Install the EVF Unit with the boss and Screw (537).
2) Connect the F.P.C. to Connector FP9902.
Camera P.C.B.
58
EVF Unit
537
boss
EVF Standby
Switch
FP9903
<Foil Side>
Fig. D6