Panasonic PV-GS29PL Service Manual page 65

15. Removal of CCD P.C.B., Filter Rubber and Optical Filter
CAUTION:
1) When removing the CCD P.C.B., take care that the
Optical Filter does not fall out.
2) Use extreme caution when removing the CCD P.C.B.
as it is easily damaged by static electricity. Use a Wrist
Strap while removing and installing.
3) Do not touch the CCD window surface.
Installation of CCD P.C.B., Filter Rubber and Optical
Filter
Install in order shown below.
1) Install the Optical Filter correctly.
Note: Make sure that no dust gets on the Optical Filter
or in the Lens Unit. Clean the Optical Filter with lens
cleaning paper dampened with lens cleaner if
necessary.
2) Install the Filter Rubber on the Optical Filter correctly as
shown below.
Note: Make sure that no dust gets on the Filter
Rubber.
3) Install the CCD P.C.B. into the Lens Unit. Then, tighten
the 2 Screws (536).
Note: Do not touch the Lens Surface. Clean the surface
with lens cleaning paper dampened with lens cleaner
if necessary.
16. Installation of Zoom Motor Unit/Focus Motor Unit
Install the Zoom Motor Unit/Focus Motor Unit so that the
Shaft of the Zoom Motor Unit/Focus Motor Unit is set in the
Holder.
shaft
Zoom
Motor
Unit
holder
Focus
Motor
Unit
Fig. D16
bosses
holder
bosses
shaft
17. Installation of EVF Slide Piece, EVF Base Frame and EVF
Frame
1) Pass the EVF F.P.C. through the EVF Base Frame hole.
2) Install the EVF Slide Pieces into the EVF Base Frame
from both sides.
3) Slide the EVF Case Ass'y to the end so that the ribs are
inserted into the holes of the EVF Slide Pieces.
4) Locate the threaded holes, and tighten the 2 Screws
(450).
5) After installing, confirm the EVF moves correctly.
6) Install the EVF Frame with the 2 Screws (537).
7) Hook both sides of the F.P.C. to the EVF Base Frame.
EVF Base Frame
EVF Case Ass'y
Slide
EVF Base Frame
537
<Bottom View>
65
PV-GS29PL / PV-GS39PL / PV-GS69PL
hole of EVF
rib
Slide Piece
hole
EVF F.P.C.
hole of EVF
rib
Slide Piece
<Top View>
(threaded hole)
450
EVF Slide Piece
<Side View>
Hooking Portion
EVF Frame
Fig. D17
537