Starting Extended Logging - Cisco TelePresence SX10 Quick Set Administrator's Manual

Cisco TelePresence SX10 Quick Set
Contents

Starting extended logging

Extended logging mode may be switched on to help diagnose
network issues and problems during call setup. While in this
mode more information is stored in the log files.
Note that extended logging uses more of your video system's
resources, and may cause your video system to under-
perform. You should only use extended logging mode when
troubleshooting an issue.
D15106.02 SX10 Quick Set Administrator Guide TC7.2, AUGUST 2014.
Introduction Web interface Web interface
Navigate to: Diagnostics > Log Files
System settings
www.cisco.com — Copyright © 2014 Cisco Systems, Inc. All rights reserved.
45
Administrator Guide
Setting passwords Appendices
Start extended logging
Click Start extended logging.
Extended logging lasts for 10 minutes. You can stop
the extended logging before it times out by clicking
the Stop extended logging button that appears when
extended logging is on.
As default, the network traffic is not captured. Use the
drop down menu if you want to include a full or partial
capture of the network traffic.