Vigor3100V - Draytek Vigor3100 Quick Start Manual

1 . 1 . 4 V i g o r 3 1 0 0 V
1 . 1 . 4 V i g o r 3 1 0 0 V
F r o n t P a n e l
F r o n t P a n e l
LED
ACT (Activity)
VPN
QoS
PRN
VoIP (2,1)
DSL
LAN LNK
(1, 2, 3, 4)
100
FDX
Interface
RST
(Factory Reset)
VoIP
DSL
LAN (1,2,3,4)
PRN
R e a r P a n e l
R e a r P a n e l
Interface
Status
Blinking
On
On
On
On
Blinking
On
Blinking
On
Off
On
Off
Blinking
Description
Restore the default settings.
Usage: Turn on the router (ACT LED is blinking). Press the hole and keep
for more than 5 seconds. When you see the ACT LED begins to blink
rapidly than usual, release the button. Then the router will restart with the
factory default configuration.
Connecters for telephone set and analog phone with VoIP communication.
Connect the G.SHDSL line to access the Internet.
Connect to the local networked devices.
Connect to the USB printer.
Description
Connecter for a power cord with 100-240 VAC (inlet).
Power Switch. "1" is ON; "0" is OFF.
Explanation
The router is powered on and running properly.
The VPN tunnel is launched.
The QoS function is active.
The USB interface printer is ready.
The phone is off hook (the handset of phone is hanging).
A phone call is incoming or on-line.
The G.SHDSL line is connected
It means that Ethernet packets are transmitting.
It means that a normal 100Mbps connection is
through its corresponding port.
It means that a normal 10Mbps connection is
through its corresponding port.
It means a full duplex connection.
It means a half duplex connection.
It means that a packet collision happens.
5