Dometic RM1350M Installation & Operating Instructions Manual page 7

installation procedure
INSTALL THE SIX SCREWS IN THE FOLLOWING
ORDER:
1. Two screws installed through the front base.
(Installation of the lower front strip.)
The refrigerator is provided with a lower front strip
(shipped as a loose part). Attach the front strip after
the refrigerator is set into the cutout opening.
a) Install the lower front strip by sliding it under the
bottom hinge plates.
b) Secure the refrigerator and the lower front strip
with two screws - one screw through each hinge.
2. Two screws installed in he top frame.
Open the doors and fasten the refrigerator with two
screws through the holes underneath the top
decoration panel.
3. Two screws installed in the rear base.
General view. Features may vary according to model.
installing the drain water hose
TO INSTALL THE DRAIN WATER HOSE, FOLLOW
THESE STEPS:
1.
2.
3.
General view. Features may vary according to model.
Ice maker
cord (optional)
- 7 -
Drill a hole through flooring. It is essential that it is
drilled in the cut out opening of the base plate at the
rear of the refrigerator.
Make sure that the hose does not kink when run
through the floor.
Seal around the hose that goes through the drilled
hole. If a longer hose than supplied is required, the
installer needs to supply one in order for the water to
drain outside of the vehicle.
Cut out opening for
drain water hose
Ice maker
cord (optional)