Common Operations; Setting The Clock; Setting The Am Tuner Interval Spacing; Turning On The Power And Selecting The Sources - JVC MX-J333VU Instructions Manual

Common Operations

Common Operations

Setting the Clock

Before operating the unit any further, first set the clock built in this
unit.
1
Press PANEL OPEN/CLOSE 5.
The unit is turned on and the Powered Rolling Panel
opens automatically.
2
Press TIMER/CLOCK h.
The hour digits start flashing on the display.
3
Press 4 ; or ¢ ; to adjust the
hour, then press SET k.
• If you want to correct the hour after pressing SET
k, press CANCEL /. The hour digits start
flashing again.
4
Press 4 ; or ¢ ; to adjust the
minute, then press SET k.
To check the clock time
Press DISPLAY c while playing any source.
• Each time you press the button, the source indiction and
the clock time alternate on the display
To adjust the clock again
If you have adjusted the clock before, you need to press TIMER/
CLOCK h repeatedly until the clock setting mode is selected.
• Each time you press the button, the timer/clock setting modes
change as follows:
DAILY
Cancelled
(The hour digits start flashing.)
When you unplug the AC power cord or if a
power failure occurs
The clock is reset to "0:00" right away, while the tuner preset stations
(see page 16) will be erased in a few days.
EN6-16;MX-J333V/PM6
PANEL
OPEN / CLOSE
TIMER
/CLOCK
PRESET
PREV NEXT
SET
PRESET
PREV NEXT
SET
DISPLAY
ON TIME REC
Clock
ON TIME
setting
7

Setting the AM Tuner Interval Spacing

Some countries space AM stations 9 kHz apart, and some countries
use 10 kHz spacing.
On the unit On the unit ONLY : :
You can only change the AM tuner interval spacing while tuning
into an AM station.
Press FM/AM u, + while holding down 7
• Each time you press the button, the AM tuner interval spacing
alternates between 9 kHz and 10 kHz.
NOTE: Preset memory lost when the interval spacing is changed.

Turning On the Power and Selecting the Sources

When you press the play button for a particular source (FM/AM,
CD 6, AUX, and TAPE 2 3 ), the unit turns on, and the Powered
Rolling Panel opens automatically (and the unit starts playing the
source if it is ready — COMPU PLAY CONTROL).
To listen to the FM/AM broadcasts, press FM/AM u, +. (See
page 16.)
To play back CDs, press CD 6 y, ). (See pages 9 – 11.)
To play back tapes, press TAPE 2 3 7, -. (See page 17.)
To select the external equipment as the source, press AUX
p, ~.
C D
FM AM /
To turn on the unit without playing, press
! so that the STANDBY lamp goes off.
The Powered Rolling Panel opens automatically.
To turn off the unit (on standby), press
again so that the STANDBY lamp lights up.
The Powered Rolling Panel also closes.
A little power is always consumed even while the unit is
on standby.
To switch off the power supply completely, unplug the AC power
cord from the AC outlet.
When select CD source, "LOADING" indicates on the display for a
few seconds.
During the LOADING indication, the unit will initialize for preparing
to play CD.
7
6/30/99, 2:26 PM
z, _.
FM AM /
TAPE
AUX
2 ,
STANDBY
2 , !
STANDBY
Continued