Troubleshooting; Specifications - JVC FSSD1000CA Instructions Manual

Troubleshooting

• If you are having a problem with your System, check this
list for a possible solution before calling for service.
Symptom
No sound is heard.
Poor radio reception
The CD skips.
The CD does not play.
Unable to operate the Remote Control.
Operations are disabled.
"NO DISC" or "0:00" appears.
Subwoofer automatically turns on, but no
sound is output.
Subwoofer does not automatically turn on.

Specifications

CA-FSSD1000
Amplifier
Output Power 38W (19 W + 19 W) at 4
30W (15 W + 15 W) at 4
Input Sensitivity/Impedance (1 kHz)
MD/AUX IN 500 mV/47 k
Output Sensitivity/Impedance (1 kHz)
MD/AUX OUT 500 mV/5 k
CD DIGITAL OUT –21 dBm - –15 dBm
(Optical out)
Speaker terminals 4
Subwoofer out 440 mV/6 k
Phones 16
0 - 15 mW/ch output into 32
CD Player
Signal-To-Noise Ratio 100 dB (typical) (94 dB (MIN))
Wow And Flutter Unmeasurable
Tuner
FM Tuner
Tuning Range 87.5 MHz - 108.0 MHz
AM Tuner
Tuning Range (MW) 522 kHz - 1 629 kHz
(LW) 144 kHz - 288 kHz
Power Specifications
Power Requirements AC 240 V ~ , 50 Hz
Power Consumption 25 W (power on mode)
1.9 W (in Standby mode)
Center Unit
Dimensions 300mm
Mass Approx. 3.0kg
22
EN
• Connections are incorrect, or loose.
• Headphones are connected.
• The antenna is disconnected.
• The AM Loop Antenna is too close to the
System.
• The FM Wire Antenna is not properly
extended and positioned.
The CD is dirty or scratched.
The CD is upside down.
• The path between the Remote Control
and the sensor on the Unit is blocked.
• The batteries have lost their charge.
The built-in microprocessor has malfunc-
tioned due to external electrical interference.
There is no disc in the tray, or CD, CD-R or
CD-RW that hasn't yet been finalized (in-
cluding blank discs) has been inserted.
The volume knob of the Subwoofer is set to
MIN position.
The volume knob of the Subwoofer is set to
MIN position. Also, the volume level of the
Unit is low.
(Max.)
(10% THD)
- 16
- 1 k
75mm 215mm (W/H/D)
VICTOR COMPANY OF JAPAN, LIMITED
• If you cannot solve the problem from the hints given
here, or the System has been physically damaged, call a
qualified person, such as your dealer, for service.
Possible Cause
Speaker Specifications (each unit)
SP-FSSD1000
Speakers
Impedance
Dimensions
Mass
Powered Subwoofer (SP-PW1000)
Speaker
Rated Impedance
Frequency Response
Output sound pressure level82 dB/W-m
Input sensitivity/Impedance
LOW LEVEL
HIGH LEVEL
Output Power
Power requirements
Power consumptions
Dimensions
Mass
Accessories
Design and specifications are subject to change without notice.
Action
• Check all connections and make correc-
tions. (See pages 4 to 8.)
• Disconnect the headphones.
• Reconnect the antenna securely.
• Change the position and direction of the
AM Loop Antenna.
• Extend FM Wire Antenna to the best
reception position.
Clean or replace the CD.
Put the CD in with the label side up.
• Remove the obstruction.
• Replace the batteries.
Unplug the System then plug it back in.
Insert a CD, CD-R or CD-RW that has been
finalized.
Adjust the volume knob.
Adjust both volume levels.
9.5cm 1cm dome
4
125mm 315mm 125mm (W/H/D)
520g
Woofer 16 cm (4 ) 1
4
30 Hz - 280 Hz
500 mV/50 k
2.1 V/1 k
90 W at 4 (Max.)
60 W at 4 (10% THD)
AC 240 V ~, 50 Hz
30 W
226mm 295mm 315 mm (W/H/D)
7.7 kg
Power Cord (1)
AM Loop Antenna (1)
Remote Control (1)
Batteries R6P (SUM-3)/AA (15F) (2)
FM Wire Antenna (1)
Signal Cord (1)
Spacers (4) (for SP-PW1000)
0301MNMCREHIT