Troubleshooting - JVC FSSD1000CA Instructions Manual

Troubleshooting

• If you are having a problem with your System, check this
list for a possible solution before calling for service.
Symptom
No sound is heard.
Poor radio reception
The CD skips.
The CD does not play.
Unable to operate the Remote Control.
Operations are disabled.
"NO DISC" or "0:00" appears.
Subwoofer automatically turns on, but no
sound is output.
Subwoofer does not automatically turn on.
22
• If you cannot solve the problem from the hints given
here, or the System has been physically damaged, call a
qualified person, such as your dealer, for service.
Possible Cause
• Connections are incorrect, or loose.
• Headphones are connected.
• The antenna is disconnected.
• The AM Loop Antenna is too close to the
System.
• The FM Wire Antenna is not properly
extended and positioned.
The CD is dirty or scratched.
The CD is upside down.
• The path between the Remote Control
and the sensor on the Unit is blocked.
• The batteries have lost their charge.
The built-in microprocessor has malfunc-
tioned due to external electrical interference.
There is no disc in the tray, or CD, CD-R or
CD-RW that hasn't yet been finalized (in-
cluding blank discs) has been inserted.
The volume knob of the Subwoofer is set to
MIN position.
The volume knob of the Subwoofer is set to
MIN position. Also, the volume level of the
Unit is low.
Action
• Check all connections and make correc-
tions. (See pages 4 to 8.)
• Disconnect the headphones.
• Reconnect the antenna securely.
• Change the position and direction of the
AM Loop Antenna.
• Extend FM Wire Antenna to the best
reception position.
Clean or replace the CD.
Put the CD in with the label side up.
• Remove the obstruction.
• Replace the batteries.
Unplug the System then plug it back in.
Insert a CD, CD-R or CD-RW that has been
finalized.
Adjust the volume knob.
Adjust both volume levels.