Table of Contents
Advertisement
6. ERROR MESSAGE
A message may appear while you are adjusting the video camera/recorder. If a message appears, refer to the following table
and take appropriate corrective action.
6.1 Error Message of Adjustment
ERROR MESSAGE
ERROR OCCURRED. IRIS TROUBLE
PRESS ANY KEY
ERROR OCCURRED ON da× ADJUSTMENT
PRESS ANY KEY
D RANGE OVER. ERROR ON da× ADJUSTMENT
PRESS ANY KEY
ERROR OCCURRED ON da0 and
PRESS ANY KEY
FILE NOT FOUND !!!!
PRESS ANY KEY
FILE OPEN ERROR !!!!
PRESS ANY KEY
ERROR OCCURRED ON C DUTY ADJUSTMENT
PRESS ANY KEY
ERROR OCCURRED ON FDET ADJUSTMENT
PRESS ANY KEY
ERROR OCCURRED. ZOOM DOES NOT WORK
PRESS ANY KEY
TOO BRIGHT
PRESS ANY KEY
TOO DARK
PRESS ANY KEY
D RANGE OVER ERROR ON HALL AMP
IRIS CANNOT OPEN ANY MORE
PRESS ANY KEY
STAURATION ERROR. TOO BRIGHT
PRESS ANY KEY
CAN'T ADJUST WHITE BALANCE
PLEASE RETRY
PRESS ANY KEY
COUNTERMEASURE
Make sure of the connection (PG1301) between lens and ANA
circuit board.
Check whether or not power is supplied.
Check the ANA circuit board and replace it if necessary.
Check the lens and replace it if necessary.
Make sure of the connection (PG1301) between lens and ANA
circuit board.
Check the ANA circuit board and replace it if necessary.
Make sure of the connection (PG1301) between lens and ANA
circuit board.
Check the ANA circuit board and replace it if necessary.
Make sure of the connection (PG1301) between lens and ANA
da1 ADJUSTMENT
circuit board.
Check the ANA circuit board and replace it if necessary.
The adjustment program (file) cannot be found.
Check the adjustment floppy disk and replace it if necessary.
The adjustment program (file) does not start.
Check the adjustment floppy disk and replace it if necessary.
Check the ANA circuit board and replace it if necessary.
Supply power again and re-adjust.
Check the ANA circuit board and replace it if necessary.
Supply power again and re-adjust.
The subject is too bright.
Move the camera further away from the light box.
The subject is too dark.
Check the light box.
Move the camera closer to the light box.
Make sure of the connection between SE and ANA circuit boards.
Check the lens and replace it if necessary.
Supply power again and re-adjust.
The subject is too dark.
Check the light box.
Move the camera closer to the light box.
Check the ANA circuit board and replace it if necessary.
Make sure of the connection (PG1301) between lens and ANA
circuit board.
Check the lens and replace it if necessary.
The subject is too bright.
Move the camera further away from the light box.
The subject is too bright or too dark.
Check the light box.
Move the camera closer to or away from the light box.
Supply power again and re-adjust.
E3 - 15
Advertisement
Table of Contents
