Table of Contents
Advertisement
2.4 Setting test equipment
1) Set the switches, knobs and each mode of oscilloscope as follows for adjustment:
Probe:
TIME/DIV:
VOLTS/DIV:
Synchronization:
AC/DC/GND:
Note: The names of switches, knobs, modes, etc. of oscilloscope may vary slightly depending on the manufacturer or
model. Since some oscilloscopes may have switches, etc. other than the above that must be set, see the instruction
manual of the particular oscilloscope for details.
COLOR
VIDEO
MONITER
YEL
10:1
10 or 20 µs (except for a case where some designation is given)
Will vary depending on the measurement object (except for a case where some designation is
given)
Internal sync (except for a case where some designation is given)
AC (except for a case where some designation is given)
REMOVE THE
ADJUSTMENT
NOT
COVER
USED
DC POWER CORD
MV100 CONNECTION
JIG
DC POWER
SUPPLY
(5V/1A)
RED
BLK
BLK
RED
YEL
BLU
DSP-R JIG
WHT
YEL
WHT
Fig. 2-1
To
AC ADAPTER/
CHARGER
PERSONAL
COMPUTER (PC)
BLK
RS232-C
CABLE
E3 - 3
Advertisement
Table of Contents
