Table of Contents
Advertisement
2.
Before Starting Disassembly
1) This video camera/recorder incorporates a laser emitter block and high-voltage section: Be sure to remove the power
supply before starting work.
2) Leave the video camera/recorder with the power supply removed for at least 10 minutes before starting work, to allow the
capacitor used for flash to discharge on its own.
3) Be sure to use only replacement parts listed in the parts list.
4) Refer to Fig. 2-1 when removing components. Reinstall the components using the reverse procedure to removal.
Interpreting the diagram in Fig. 2-1
Find the component to be removed, and trace the line in the direction of arrows till the end.
Remove the components on the line before removing the target component.
Proceed with disassembly in the reverse direction to the arrows, starting from components on right. (Numbers in
brackets [
] show the item number in disassembly procedure.)
Example 1:
Before removing the microphone, the top cover, R-block, L-block, front block JKR circuit board and JKF
circuit board jack unit must previously be removed in this order.
Example 2:
The LCD-U case can be removed without removing any other components.
GYR Circuit Board,
SEN Circuit Board,
Sensor,
Lens
[3.9]
LSP Shield,
Side Case-L
[3.5]
ANA Circuit Board
Camera Unit
[3.5]
[3.5]
DIG Circuit Board
[3.5]
JKR Circuit Board,
Microphone,
JKF Circuit Board
IR Filter,
[3.3]
Front Case
[3.3]
Jack Cover
[3.3]
Flash Unit
[3.3]
B/W LCD,
LCD Frame,
LCD Power Unit
Backlight,
[3.11]
Color LCD,
LCD-B Case
[3.11]
Power Terminal
[3.4]
EVF-B Case,
EVF-F Case,
EVF LCD,
Plate-F
EVF Backlight,
[3.10]
EBL Circuit Board
[3.10]
Lock Unit,
Loader,
Side Case-R
Mechanism Unit
[3.8]
[3.7]
Fig. 2-1 Procedure
Front Block
Top Cover,
R-Block,
[3.2]
L-Block
[3.1]
Lens Hood
[3.3]
LCD Block
LCD-U Case
[3.2]
[3.2]
RUB Sheet
[3.2]
EVF Block,
Rear Cover
[3.4]
Eye Control
[3.10]
Switch Unit
[3.6]
Link Braket R,
Disc Cover
Link Braket L
[3.6]
[3.7]
E2 - 3
Advertisement
Table of Contents
