Hyundai 2001 Tiburon Owner's Manual page 93

D060C01A-AAT
2. Block the Wheel
Flat tire
Block the wheel that is diagonally opposite from
the flat to keep the vehicle from rolling when the
car is raised on the jack.
D060D01A-AAT
3. Loosen Wheel Nuts
WHAT TO DO IN AN EMERGENCY
The wheel nuts should be loosened slightly
before raising the car. To loosen the nuts, turn
the wrench handle counterclockwise. When
doing this, be sure that the socket is seated
completely over the nut so it cannot slip off. For
maximum leverage, position the wrench so the
handle is to the right as shown in the drawing.
Then, while holding the wrench near the end of
the handle, pull up on it with steady pressure.
Do not remove the nuts at this time. Just loosen
them about one-half turn.
SSA3050D
D060E01A-AAT
4. Put the Jack in Place
The base of the jack should be placed on firm,
level ground. The jack should be positioned as
shown in the drawing.
FUA3070E
D060F01A-AAT
5. Raising the Car
Install the jack handle into the jack as shown in
the drawing. To raise the vehicle, turn the jack
handle clockwise. As the jack begins to raise
the vehicle, double check that it is properly
positioned and will not slip. If the jack is on soft
ground or sand, you may find it necessary to
place a board, brick, flat stone or other object
under the base of the jack to keep it from
sinking.
Raise the car high enough so that the fully
inflated spare tire can be installed. To do this,
you will need more ground clearance than is
FUA3072A
required to remove the flat tire.
WARNING:
Do not get under the car when it is support-
ed by the jack! This is very dangerous as the
could fall and cause serious injury or death.
FUA3070G
3-5