Reset The Settings/Reboot The Camera [Default Reset] - Panasonic WV-TW310L Operating Instructions Manual

9 Maintenance of the camera [Maintenance]
IMPORTANT
•
After completing the upgrade, delete temporary internet files. (®page 47)
•
Upgrade the firmware using a PC in the same subnet as the unit.
•
Follow the instructions from the dealer when upgrading the firmware.
•
When upgrading the application software, use the designated file (extension: img) for the firmware
upgrade.
The name of the firmware to be used for the upgrade should be "model name (Use small letters.
"WV-" is not required.)_xxxxx.img".
* ("xxxxx" indicates the version of the firmware.)
•
Do not turn off the power of the camera during the upgrade process.
•
Do not perform any operation during upgrading and wait until it completes.
•
The following network settings will not be reset when upgrading the firmware after selecting "Reset the
settings to the default after completing the upgrade. (Except the network settings)".
IP address, subnet mask, default gateway, HTTP port, line speed, time & date
•
The viewer software used on each PC should be licensed individually. Refer to your dealer for the
software licensing.
9.3 Reset the settings/Reboot the camera [Default
reset]
Click the [Default reset] tab of the "Maintenance" page. (®page 14, page 16)
The settings and the HTML data of the camera can be initialized and reboot of the camera can be performed
on this page.
[Reset to the default (Except the network settings)]
Click the [Execute] button to reset the settings to the default. Note that the network settings will not be reset.
It is impossible to operate the camera for about 3 minutes after the initialization.
[Load the default HTML files (setup menu).]
Click the [Execute] button to reset the HTML files to the default.
It is impossible to operate the camera for about 3 minutes after the initialization.
[Reset to the default and load the default HTML files.]
Click the [Execute] button to reset the settings of the camera and the HTML files to the default. Note that the
network settings will not be reset.
It is impossible to operate the camera for about 3 minutes after the initialization.
[Reboot]
Click the [Execute] button to reboot the camera. It is impossible to operate the camera for about 2 minutes
after rebooting the camera.
40 Operating Instructions