White Balance - Panasonic WV-TW310L Operating Instructions Manual

In the area of 50 Hz power supply frequency:
3/100s, 2/100s, 1/100s
In the area of 60 Hz power supply frequency:
3/120s, 2/120s, 1/120s
•
Under extremely strong lighting, flickering may happen even when "Indoor scene" is selected for "Light
control mode".
•
The following can reduce flickering.
–
Moderate the illumination intensities of objects by changing the camera direction.
•
When "On" is selected for "Wide dynamic range (WDR)", only "Indoor scene (50 Hz)", "Indoor scene
(60 Hz)", and "ELC(1/30s)" are available.
[AGC]
Select a method of gain adjustment from the following.
•
On(High)/ On(Mid)/ On(Low): When the luminance of the subject becomes darker, gain will be
automatically increased and screen will become brighter. "High", "Mid" and "Low" are indications of gain
level.
•
Off: Images will be captured with the fixed gain level.
•
Default: On(Mid)
[Day & Night(electrical)]
Select switching between the color mode and the black & white mode from the following.
•
Off: The color mode is selected.
•
Auto: Switches from color to black-and-white images when the ambient brightness (illuminance) of the
camera is approx. 6 lx or less. It takes time to switch between modes.
•
Default: Off

[White balance]

Select a method of white balance adjustment from the following.
White color can be adjusted by "Red gain" and "Blue gain".
•
ATW1: Selects the automatic tracing white balance mode. The camera will constantly check the color
temperature of the light source and adjust the white balance automatically. Operating color temperature
range is approx. 2,700 K - 6,000 K.
•
ATW2: Selects the automatic tracing white balance mode under a sodium lamp. The camera will adjust
the white balance automatically under a sodium lamp. Operating color temperature range is approx.
2,000 K - 6,000 K.
•
AWC: Selects the automatic white balance control mode. This adjustment is suitable for a location where
a light source is stable. Operating color temperature range is approx. 2,000 K - 10,000 K.
•
Default: ATW1
Note
•
Under the following conditions, color may not be faithfully processed. In these cases, select "AWC".
–
When shooting a subject whose major part is a thick color
–
When shooting blue sky or sun at sunset
–
When shooting a subject whose luminance is too low
•
When "AWC" is selected, click the [Set] button.
[Red gain]
Adjust the red color of images.
When the cursor is moved in the "+" direction, the red color will become thicker. When the cursor is moved in
the "-" direction, the red color will be thinner. Click the [Reset] button to reset the color to the default.
•
Default: 128
6 Configure the settings relating to images [Image]
Operating Instructions 29