Philips Pocket Memo 9450 Instruction Manual page 5

Operating instruction
Use Voice Command - assigning an ID number to your dictation
When using the VC, the DPM expects your input before it can display it on the display and link it
internally to the appropriate dictation file.
Using Voice Command:
1. The DPM must be in Stop Mode (4 position switch in stop).
2. Press and hold down the DL/VC button during the entire VC procedure; say the first number/word of
the ID number. If recognized, this will be displayed on the LED - see Figures A and B.
3. Say the next number/word. See Figures C and D. The current character flashes. This can be
modified/corrected if necessary. See Modify/correct.
4. When your entry is finished, briefly press the Jog Dial; the full ID number is now assigned to your
dictation file and you can start to dictate.
Figure A: Start recognition
Note: • A keyword/ID number can have a maximum of 15 positions (if there are more than 7 positions, the characters will be reduced in size to fit
in the display); these can be numbers, letters or special characters supported by the DPM which have been trained by you and are acoustically
different from each other.
Modify/correct: If you release the DL/VC button during an input session, this will not cancel the
command (!) - this is equivalent to a pause ... • ... while you check an ID number, • ... while you
modify/correct the current (flashing) input by turning the Jog Dial (+/-), • ... while you delete the
current (flashing) input using the DEL button. You can return to the VC mode at any time by pressing
the DL/VC button again.
Retraining: If you are not satisfied with the recognition result for a character, you can return at ant time
and redo training. You do this by speaking over the previous result. – For example, you are not satisfied
with the result for „two":
• Open the DPM menu and press the Jog Dial.
• Go to the number „2". The symbol is marked with
training session. Retraining
• Press the DL/VC button to start the Retraining procedure and say the
number/word. Continue as with the initial training procedure
Details about the configuration possibilities of Voice Command can be found under
„User Manual" on the CD-ROM.
Voice Command
Figure B: 1st number recognized
(see Figure E).
Figure C: 2nd number recognized
from the previous
.
Figure D: 6th number recognized
Figure E: Retraining