Mount Into The Dashboard - Philips CMD310 User Manual

Mount into the dashboard

1
If the car does not have an on-board drive
or navigation computer, disconnect the
negative terminal of the car battery.
‡ If you disconnect the car battery in
a car that has an on-board drive or
navigation computer, the computer
may lose its memory.
‡ If the car battery is not disconnected,
to avoid short-circuit, make sure that
the bare wires do not touch each
other.
2
Make sure that car dashboard opening is
within these measurements:
3
Install the sleeve into the dashboard and
EHQG WKH WDEV RXWZDUG WR À[ WKH VOHHYH
Note
‡
,I WKH V\VWHP LV QRW À[HG E\ VOHHYH EXW E\ WKH VXSSOLHG
screws, skip this step.
1 8
3 m
m
4
Place the supplied rubber cushion over the
end of the mounting bolt.
5
Slide the system into the dashboard until
you hear a "click".
EN 11