Related Manuals for Philips CMD305A
Summary of Contents for Philips CMD305A
- Page 1 Always there to help you Register your product and get support at www.philips.com/welcome CMD305A Question? Contact Philips User manual...
-
Page 3: Table Of Contents
Contents Adjust the dock bracket Install the CarStudio application Use the CarStudio application Charge your phone 1 Important Undock your phone Safety Store the dock bracket 2 Your car audio system 10 Adjust sound Introduction Adjust the volume level What's in the box Mute sound Overview of the system Use the DBB sound effect... -
Page 4: Important
1 Important • Risk of damage to your phone: Unload your Android-powered mobile phone from the dock before you store the dock bracket. Safety Read and understand all instructions before you use the device. If damage is caused by failure to follow instructions, the warranty does not apply. -
Page 5: Your Car Audio System
Congratulations on your purchase, and • Android-powered phones welcome to Philips! To fully benefit from the • Android version: V2.2 or above support that Philips offers, register your product • Bluetooth version: V2.1 or above at www.philips.com/welcome. • Charging through the micro USB connector/socket • Width: between 52 mm and 73 mm... -
Page 6: Overview Of The System
Overview of the system • In radio mode, press to select the • Press to answer or redial a call. preset radio station of No. 2. • Press to hang up a call. • In radio mode, press and hold to store the current radio station at channel • Tune to a radio station. -
Page 7: Lcd Screen
• In radio mode, press to select the • Press to turn on the system. preset radio station of No. 4. • Press and hold to turn off the system. • In radio mode, press and hold to store • Press to mute the system or release it the current radio station at channel from mute status. -
Page 8: Before Use
Check the car's wiring carefully, and then sequence. connect them to the supplied ISO wires. If you contact Philips, you will be asked for the model number and serial number of your car audio system. The model number and serial number are on its bottom. - Page 9 Connector Connect to Connector Connect to 4 Red wire The +12V power terminal ANTENNA Antenna for radio which is live in the accessory External Mic An external (ACC) position of the ignition microphone for switch. If there is no accessory phone call position, connect to the +12V SUBWOOFER...
- Page 10 Make sure that the car dashboard opening Slide the system into the dashboard until is within these measurements. you hear a "click". Attach the trim plate. Install the sleeve into the dashboard and bend the tabs outward to fix the sleeve. Note • If the system is not fixed by sleeve but by the supplied screws, skip this step. Reconnect the negative terminal of the car battery.
-
Page 11: Get Started
4 Get started repeatedly until [CLOCK] and the Press current time are displayed. » If the clock is not set before, [--:--] is displayed. Rotate to set the hour. Power on Press to confirm. Rotate to set the minute. Press » [WELCOME] scrolls. Press to confirm. -
Page 12: Listen To Radio
5 Listen to radio Tune to a radio station Press repeatedly to switch the source to [RADIO]. repeatedly to select a band: [FM1], Press Select a radio region [FM2], [FM3], [MW1], or [MW2]. Press and hold until the You can select a radio region that matches your frequency digits blink. -
Page 13: Tune To A Preset Station
Repeat steps 2 and 3 to store more radio Rotate to select a program type, and stations. then press to confirm. • To replace a radio station, store Item Program Description another one in its channel. type NEWS News services Tune to a preset station AFFAIRS Politics and current affairs... - Page 14 announcement is over, the system Use alternate frequencies returns to the previous mode. • [TA OFF]: Traffic announcement does If the signal of an RDS station is poor, enable not cut in. the AF (Alternate Frequency) function to search for another station that transmits the same program.
-
Page 15: Use Bluetooth Devices
Enable it to search for other Bluetooth (AVRCP) profile, you can control play on the devices. system. In the device list, select CMD305A. Connect the Bluetooth device to this system via Bluetooth. Enter the default password "0000". » If the pairing is successful, [PAIR OK]... -
Page 16: Make A Call
Transfer a phone call to mobile phone Note By default, voice comes from the loudspeakers • If the connected device does not support the AVRCP profile, control play on the connected device. during a call. until [TRANSFER] is Press and hold displayed. » The loudspeakers are muted, and the Make a call voice comes from your mobile phone only. -
Page 17: Play From A Usb Storage Device
7 Play from a USB Control play storage device During play, follow the instructions below to control play. Buttons Functions This system can play .mp3 and .wma files that are copied onto a compatible USB storage Pause or resume play. device. Skip to the previous or next track. Press and hold to rewind a track or Note search forward fast within a track. -
Page 18: Listen To An External Device
8 Listen to an 9 Use the dock external device An application Philips CarStudio is available on Google Play Store for this car audio system. You can use the system to amplify the audio To enjoy full features, download and install the input that is transferred from an external application to your Android-powered phone. -
Page 19: Connect Your Phone
Pull out the dock bracket until you see the Connect your phone yellow lines and hear a "click". You can connect your phone to the dock directly or though the supplied USB cable. Dock your phone Note • Make sure that the width of your phone is between 52 mm and 73 mm. -
Page 20: Adjust The Dock Bracket
Connect your phone to the dock with its screen facing you. • To match the USB socket of your phone, turn the USB connector by 180° as illustrated if necessary. Connect the USB cable between • the USB socket of your phone, and •... -
Page 21: Install The Carstudio Application
Run the Google Play Store (Play store) Adjust the viewing angle. application on your phone. Switch to portrait mode Turn the dock bracket clockwise by 90 degrees. to display the search interface. Adjust the viewing angle. Install the CarStudio application Note •... -
Page 22: Use The Carstudio Application
(see “Pair a device”). Tap the icon of CarStudio application to run it on your phone. » The main interface is displayed. Tap Philips CarStudio in the search result list. Tap Install (Install) and then Accept & download (Accept & download) to start the download and installation. -
Page 23: Charge Your Phone
• To switch the interface for more Undock your phone features, swipe on the screen. Tap an icon to access its feature or change settings. • (phone): Make a phone call Note • (map): Run the map application that • Before you undock your phone, make sure that the is installed on your phone. -
Page 24: Store The Dock Bracket
10 Adjust sound Store the dock bracket The following operations are applicable to all Note compatible media. • Before storage, make sure that you have unloaded your phone and pinched the hooks. Adjust the volume level Flip the dock bracket downwards until you hear a "click". -
Page 25: Enable The Full-Range Sound
11 Adjust system • [FRONT]: For front passengers only Rotate to select a setting. settings Enable the full-range sound Press and hold to access the system Press repeatedly to select one of the menu. following settings. Press repeatedly until one of the [FULL ON]: Enable the full-range sound •... -
Page 26: Additional Information
12 Additional information Reset the system You can reset the system to factory default settings. Note • If the fuse gets damaged immediately after it is replaced, an internal malfunction may occur. In this case, consult your WOOX Innovations retailer. Open the protective cover for the USB socket, MP3-LINK socket, and RESET button. -
Page 27: Product Information
13 Product Bluetooth information Output power 0 dBm (Class 2) Frequency 2.4000 GHz - 2.4835 GHz ISM band Band Range 3 meters (10 feet in free space) Note Standard V2.0 • Product information is subject to change without prior notice. General Power supply 12 V DC (11V - 16V),... -
Page 28: Troubleshooting
(www.philips.com/support). When you contact • The Bluetooth function of the device is not Philips, make sure that the product is nearby enabled. Refer to the user manual of the and the model number and serial number are device for how to enable the function. -
Page 29: Notice
This product complies with the radio reserved. interference requirements of the European Specifications are subject to change without Community. notice. Philips and the Philips’ Shield Emblem are registered trademarks of Koninklijke Philips N.V. and are used by WOOX Innovations Care of the environment Limited under license from Koninklijke Philips N.V.. - Page 30 WOOX Innovations, and is the manufacturer of the product. WOOX Innovations is the warrantor in relation to the product with which this booklet was packaged. Philips and the Philips Shield Emblem are registered trademarks of Koninklijke Philips N.V. CMD305A_05_UM_V3.0_EN...