Connecting Example : Av Equipment - Panasonic PT-VZ570 Operating Instructions Manual

<HDMI 1 IN> terminal and <HDMI 2 IN> terminal pin assignments and signal names
Outside view
Even-numbered pins
Odd-numbered pins

Connecting example : AV equipment

D-sub / component
Conversion cable
Attention
f Always use one of the following when connecting a VCR.
- A VCR with built-in time base corrector (TBC).
- A time base corrector (TBC) between the projector and the VCR.
f If nonstandard burst signals are connected, the image may be distorted. In such case, connect the time base corrector
(TBC) between the projector and the external devices.
Note
f For an HDMI cable, use an HDMI High Speed cable that conforms to HDMI standards. If a cable that does not conform to
HDMI standards is used, images may be interrupted or may not be displayed.
f This projector does not support the Viera link (HDMI).
f When input the Y/C signal to the <COMPUTER 1 IN> terminal, please prepare a necessary D-SUB - S Video conversion
cable (ET-ADSV).
f If the [AUDIO IN SELECT] settings are incorrect, the projector may have malfunctions such as the absence of audio.
f When the <VARIABLE AUDIO OUT> terminal is connected with cable, the sound will not be output from the built-in speaker.
32 - ENGLISH
Chapter 2 Getting Started - Connecting
Pin No.
to
to
Blu-ray disc player
with HDMI terminal
D-SUB - S Video
conversion cable
S-video cable
DVD player
Signal names
T.M.D.S data 2+
T.M.D.S data 2 shield
T.M.D.S data 2 -
T.M.D.S data 1+
T.M.D.S data 1 shield
T.M.D.S data 1 -
T.M.D.S data 0+
T.M.D.S data 0 shield
T.M.D.S data 0 -
T.M.D.S clock +
Video deck
(TBC built-in)
MIC
Audio equipment
DVD player
Pin No. Signal names
T.M.D.S clock shield
T.M.D.S clock -
CEC
—
SCL
SDA
DDC/CEC GND
+5V
Hot plug detection