Making Adjustments And Selections - Panasonic PT-VZ570 Operating Instructions Manual

Initial setting (projector setup)
Set each item.
1) Press as to select an item.
Item
[PROJECTION METHOD]
[SCREEN FORMAT]
[SCREEN POSITION]
[STANDBY MODE]
2) Press qw to switch the setting.
3) Press the <ENTER> button.
f Confirm the setting value and complete the initial setting.
Note
f If you press the <RETURN> button in the initial setting (projector setup) screen, you can go back to the initial setting (display
language) screen.

Making adjustments and selections

It is recommended that images are projected continuously for at least 30 minutes before the focus is adjusted.
1) 8) 7) 9)
4)
1) Rotate the focus lever to adjust the focus of the projected image roughly. (x page 39)
2) Change the settings of the [PROJECTOR SETUP] menu → [PROJECTION METHOD] depending on the
installation mode. (x page 71)
f Refer to "Navigating through the menu" (x page 46) for the operation of the menu screen.
3) Press the <INPUT SELECT> button on the control panel or the input selection (<COMPUTER 1>,
<COMPUTER 2>, <VIDEO>, <HDMI 1> or <HDMI 2>) buttons to select the input signal.
4) Adjust the front, back and sideway tilt of the projector with the adjustable feet. (x page 29)
Chapter 3 Basic Operations - Powering on/off the projector
Set [PROJECTION METHOD] depending on the installation mode.
After completed the initial setting, you can change the setting from the
[PROJECTOR SETUP] menu → [PROJECTION METHOD].
Set the screen format (aspect ratio) and display position of the image.
After completed the initial setting, you can change the settings of each
item from the [DISPLAY OPTION] menu → [SCREEN SETTING].
Set the display position of the image. After completed the initial setting,
you can change the settings of each item from the [DISPLAY OPTION]
menu → [SCREEN SETTING].
Set the operation mode during standby. The default setting is [NOR-
MAL], you can use the network function during standby. If you want to
reduce the power consumption, it can be set to [ECO]. After completed
the initial setting, you can change the setting from the [PROJECTOR
SETUP] menu → [ECO MANAGEMENT] → [STANDBY MODE].
4)
Description
5)
Page
71
66
66
73
6)
3)
3)
6)
ENGLISH - 37