Abbreviated Ascii Table - Metrologic MS9520 Installation And User Manual

Ms9500 voyager series single-line hand-held laser scanner

Hide thumbs Also See for MS9520:

Product manual (12 pages)

Specification sheet (2 pages)

Installation and user manual (56 pages)

Table Of Contents

Table of Contents

ROGRAMMING

EXAMPLE #3:

The following example shows the events that occur when an invalid bar code

is sent. This sample will load the factory default settings and then set the

baud rate to 19200.

FEATURE

Enter Program Mode

Load Defaults

Invalid command was sent, you must start over!

Enter Program Mode

Load Defaults

19200 Baud Rate

Exit Program Mode

The scanner will beep three times!

This example illustrates two important points.

First, if an invalid command is sent from the host, the scanner responds with

a [nak] and the end-user must start over from the beginning.

Second, if a command is sent to change the Baud Rate, the new baud rate

does not take effect until after the end-user exits program mode.

(

ODES

CONTINUED

HOST

COMMAND

[stx]999999[etx]

[stx]99999:[etx]

[stx]999999[etx]

[stx]999998[etx]

[stx]415870[etx]

[stx]999999[etx]