Using Recording Timer - JVC CA-MXJ770V Instructions Manual

6
When selecting "– CD – –".
1) Press 4 or ¢ to select the disc
number, then press SET.
2) Press 4 or ¢ to set the track
number, then press SET.
The unit enters volume setting mode.
When selecting "TUNER FM" or
"TUNER AM".
Press 4 or ¢ to select the preset station number, then
press SET.
The unit enters volume setting mode.
7
Press 4 or ¢ to set the
volume level.
• You can select the volume level from
among the following — "VOL – –" ,"VOL 05",
"VOL 10" and "VOL 15"
If you select " VOL – –" the volume is set to the last
level before the unit was turned off.
8
Press SET to complete the Daily
Timer setting.
The DAILY (Daily Timer) indicator stops
flashing and remains lit. The settings you have entered are
shown on the display in sequence.
9
Press to turn off the unit (on
standby) if you have set the Daily
Timer with the unit turned on.
To turn on or off Daily Timer after its
setting is done
1 Press CLOCK/TIMER repeatedly until
"DAILY" appears on the display.
2 To turn off the Daily Timer, press
CANCEL.
The DAILY (Daily Timer) indicator goes off
from the display ("OFF" appears for a while).
The Daily Timer is canceled, but the setting for
the Daily Timer remains in memory.
To turn on the Daily Timer, press SET.
The DAILY (Daily Timer) indicator lights up
on the display. The settings you have entered
are shown on the display in sequence for your
confirmation.
If the unit is turned on when the timer-on time comes
Daily Timer does not work.

Using Recording Timer

PREV NEXT
With Recording Timer, you can make a tape of a radio
broadcast automatically.
How Recording Timer works
The unit automatically turns on, tunes into the specified
station, sets the volume level to "MIN," and starts recording
when the turn-on-time comes (the
before the turn-on-time, and continues flashing while the
timer is operating). Then, when the turn-off-time comes
("OFF" appears just before the turn-off-time), the unit
automatically turns off (stands by).
The timer setting remains in memory until you change it.
PREV NEXT • There is a time limit for performing the following steps. If
the setting is canceled before you finish, start from step 1
again.
• If you have made a mistake while setting the timer, press
CANCEL. (However, this does not always work. If
CANCEL does not work, press CLOCK/TIMER repeatedly
and start from step 1 again.)
On the unit ONLY:
1
Put a recordable cassette into deck B.
2
Press CLOCK/TIMER until "REC"
appears on the display.
The REC (Recording Timer) indicator also
starts flashing on the display.
• Each time you press the button, the timer setting modes
change as follows:
DAILY
Canceled
3
Press CLOCK/TIMER again.
"ON TIME" appears for 2 seconds, then the
unit enters turn-on-time setting mode.
– 27 –
Continued
indicator flashes just
ON TIME REC
Clock
ON TIME
setting
(See page 9.)