Table of Contents
Advertisement
DESIGN
The BoilerMate A-Class HP-DEM is designed to be sold as part of a package with the
Mitsubishi Electric Ecodan air source heat pump. The combination of the BoilerMate
A-Class HP-DEM and the Mitsubishi Electric Ecodan air source heat pump has been
the subject of independent testing by BRE and a report is available on request.
Any water distribution and central heating installation must comply with the relevant
recommendation of the current version of the Regulations and British Standards
listed below:-
Building Regulations
I.E.E. Requirements for Electrical Installations (BS7671)
Water Regulations
Manual Handling Operations Regulations
British Standards
BS6798, BS5449, BS5546, BS5440:1, BS5440:2, CP331:3, BS6700, BS7593 and BS7671.
Health and Safety Document No 635
A competent person as stated in the Building Regulations must install the BoilerMate
heating system. The manufacturer's notes must not be taken as overriding statutory
obligations.
The BoilerMate A-Class HP-DEM model is based on an Accolade unvented hot
water storage appliance and therefore is covered by section G3 of the Building
Regulations. Unless the installer is part of an approved competent installer
scheme the installation is notifiable to Building Control prior to commencement.
An annual inspection is recommended to ensure safe, long term operation.
BMA 180 HP-DEM
This appliance must only be used with suitable heat pumps and is not suitable
for use with any uncontrolled energy source such as solid fuel/steam. It should
not be installed where the annual inspection is likely to be neglected.
The information in this manual is provided to assist generally in the selection of
equipment. The responsibility for the selection and specification of the equipment
must however remain that of the customer and any Designers or Consultants
concerned with the design and installation.
Please note: We do not therefore accept any responsibility for matters of design,
selection or specification or for the effectiveness of an installation containing one of
our products unless we have been specifically requested to do so.
All goods are sold subject to our Conditions of Sale, which are set out at the rear
of this manual.
In the interest of continuously improving the BoilerMate range, Gledhill Water Storage
Ltd reserve the right to modify the product without notice, and in these circumstances
this document, which is accurate at the time of printing, should be disregarded. It will
however be updated as soon as possible after the change has occurred.
Modifications must not be made to this appliance. If any components are replaced in
the field, they must be obtained from Gledhill Water Storage to ensure continued safe
operation and must not be tampered with. This applies particularly to the immersion
heaters which incorporate a pre-set overheat thermostat.
BMA 210/240 HP-DEM
Page 5
Advertisement
Table of Contents
