Table of Contents
Advertisement
Display
1
2 3 4 5 6
ANALOG INPUT
-
1 OVER indicator
This indicator turns on when the input level of the ana-
logue signal is too high or when the signal level during
the internal DSP operation is too high.
Adjust the input gain when this indicator turns on.
2 MIDNIGHT indicator
This indicator turns on when the Midnight function is on.
3 Hi-bit indicator
This indicator turns on when the Hi-bit function is on.
4 DIRECT indicator
This indicator turns on when the Direct function is on.
5 NETWORK indicator
This indicator turns on when the amplifier is set to Digi-
tal Network (Channel Divider) mode.
6 DNR indicator
This indicator turns on when the digital NR function is on.
7 Character display
This display shows alphanumeric characters and sym-
bols to convey various types of information.
8 LFE indicator
The LFE indicator turns on when LFEs (low frequency
effect) are contained in the playback software. When
LFE signals are actually played back (LFE signals do
not exist in the entire sound track), the ÷ mark next to
the LFE indicator turns on.
9 Program Format indicator
The channel indicators corresponding to the input sig-
nals turn on when a PDIF connection is made or when
a Dolby Digital or DTS signal is input.
L:
Front left channel
C:
Centre channel
R:
Front right channel
LS:
Surround left channel
S:
Surround channel (monaural)
RS:
Surround right channel
LFE: LFE signal
7
=
0 UNLOCK indicator
This indicator turns on when the digital input signal is
cut off.
- Sampling Frequency indicator
This indicator displays the sampling frequency (fs) of
the digital REC OUT signal selected in the section "Se-
lecting the Digital Output Sampling Frequency during
Analogue Input".
96 : 96 kHz
48 : 48 kHz
= Input indicator
The indicator for the input signal selected by the INPUT
SELECTOR turns on.
~ 2 Surround/DTS Mode indicator
DTS:
DOLBY DIGITAL:
DOLBY PRO LOGIC: This indicator turns on when play-
! DIGITAL INTERFACE indicator
This indicator turns on when using the INPUT SELEC-
TOR to choose the input signals when a PDIF connec-
tion is made.
C-AX10
8 9 0
~
!
This indicator turns on when DTS
signals are input while Ÿ/DTS
mode is on.
This indicator turns on when play-
ing back Dolby digital signals
while Dolby Surround/ mode is
on. However, DOLBY PRO
LOGIC turns on when playing
back Dolby Digital signals re-
corded in two channels.
ing back a two-channel source in
DOLBY PRO LOGIC while Dolby
Surround/DTS button is on.
117
Advertisement
Table of Contents
