Pioneer C-AX10 Service Manual page 116

C-AX10
! All Tone Control button (ALL)
This button is used to perform total tone control at the
same settings for the front, centre, and surround chan-
nels.
@ Front Tone Control button (FRONT)
This button is used to perform tone control for the front
channels.
# MIDNIGHT button
This button turns the Midnight function on and off.
$ DIRECT button
This button is used to select the Direct function mode.
% Memory button (MEMO)
This button is used when saving the sound memory
settings.
^ Brightness Selection button (DIMMER)
The display brightness can be adjusted to four levels
including Display Off.
& Master Volume buttons (VOLUME +, –)
These buttons are used to adjust the volume.
* Muting button (MUTING)
This button is used to temporarily turn off the sound.
( NETWORK SET UP button
This button is used to enter Network Setup mode when
the Output mode is set to Digital Network (IIR or FIR).
) TEST TONE button
This button is used to adjust the level using the test
tone.
_ ENTER button
This button is used to enter selections and make set-
tings.
+ INPUT GAIN button
This button is used to enter the mode for adjusting the
analogue input and digital input gain.
¡ Surround Tone Control button (SURR.)
This button is used to perform tone control for the sur-
round channels.
™ Centre Tone Control button (CENTER)
This button is used to perform tone control for the cen-
tre channel.
116
Operating Range of the Remote Control
When using the remote control to operate the amplifier, point
the remote control towards the remote control sensor on the
front panel.
Remote control
sensor
• The remote control may not operate when there are ob-
jects between the remote control and amplifier or when
the remote control is used at a wide angle from the sen-
sor.
• The amplifier may malfunction if sunlight, fluorescent
lights, or other strong lighting shines directly on the re-
mote control sensor.
• The amplifier may malfunction if it is used near devices
that emit infrared beams or when other remote control
devices that use infrared beams are used. Conversely,
this remote control can also cause other similar devices
to malfunction when used in the same area.