Pioneer C-AX10 Service Manual page 114

C-AX10
When the front flip-down door is opened
% CHARACTER INPUT button
This button is used to enter the Character Input mode
for changing the input signal or sound memory setting
to a user-selected name.
^ Digital REC Selector button
(REC SELECTOR [DIGITAL] )
This button is used to enter the mode for selecting the
REC OUT signal that is output from the digital output
jack.
& INPUT GAIN button
This button is used to enter the mode for adjusting the
analogue input and digital input gain.
* PARAMETER CHECK button
This button is used to enter the mode for checking the
current settings.
( Tone Control button (TONE)
This button is used to enter Tone Control mode.
) Tone Control Channel button (EACH/ALL)
This button is used to switch between EACH mode and
ALL mode.
÷ EACH mode
: The front, centre, and surround
channels can each be set individu-
ally.
÷ ALL mode
: The front, centre, and surround
channels are set to the same set-
tings.
114
0 - = ~ !@ # $
% ^ & * ( ) _ + ¡ ™
_ Balance Control button (BALANCE)
+ SYSTEM SET UP button
¡ NETWORK SET UP button
™ OUTPUT MODE selector
This button is used to enter the mode for adjusting the
balance of the front left and right channels.
This button is used to enter System Setup mode for
speaker setup or selecting modes.
This button is used to enter Network Setup mode when
the OUTPUT MODE selector (™) is set to Digital Net-
work FIR mode or Digital Network IIR mode.
This selector is used to set to one of the following four
modes.
÷ Digital Network FIR mode
÷ Digital Network IIR mode
÷ Normal mode
÷ OFF (Output off)
After pressing the buttons in % to ¡, use the MULTI
CONTROL jog dial 8 to make the settings and adjust-
ments.
DOLBY
D I G I T A L