Download Print this page
JVC SP-F508 Instructions
JVC SP-F508 Instructions

JVC SP-F508 Instructions

Jvc speaker system instructions

Advertisement

Quick Links

SP-F508
SPEAKER SYSTEM
INSTRUCTIONS
Before you begin using these speakers, please read the instructions carefully to be sure you get the best possible performance.
7
Precautions for installation
• Do not install the speakers on an uneven surface or in a place
subject to vibration; otherwise, they may fall over, causing
damage or injury.
– Take the occurrence of earthquakes or other
physical shocks into consideration when
selecting the installation place, and secure the
speakers thoroughly.
• To prevent deformation or discoloration of the
cabinet, do not install the speakers where they are
exposed to direct sunlight or high humidity, and
avoid installation near air conditioning outlets.
• Speaker vibrations may cause howling. Place the
speakers as far away from the player as possible.
• The speakers are magnetically shielded to avoid
color distortions on TVs. However, if not installed properly, it
may cause color distortions. So, pay attention to the following
when installing the speakers.
– When placing the speakers near a TV set, turn off the TV's
main power switch or unplug it before installing the
speakers.
Then wait at least 30 minutes before turning on the TV's
main power switch again.
Some TVs may still be affected even though you have followed
the above. If this happens, move the speakers further away
from the TV.
• Tuner reception may become noisy or hissing if a speaker is
installed near the tuner. In this case, leave more distance
between the tuner and the speakers or use an outdoor
antenna for better tuner reception without interference from
the speakers.
• Do not lean against the speakers, as the speakers could fall
down or break, possibly causing an injury. Especially be
careful that children do not lean against them.
Thank you for purchasing a JVC speaker system.
If you have any questions, consult your JVC dealer.
Warnings, Cautions and Others
7
• To maintain the appearance of the speakers
• To improve the sound field
• To use the speakers without any trouble
7
• Base plates (2)
• Speaker grilles (2)
• Speaker cords (4 m, 2)
• Screws (M4 x 20 mm, 8)
If any item is missing, contact your dealer immediately.
Precautions for daily use
Wipe with a dry, soft cloth if the cabinet should become dirty.
If very dirty, apply a small amount of water or neutral detergent
to the cloth and wipe clean, then wipe with a dry cloth.
– It is recommended to leave a space of more than 50 cm
between the speakers and the wall.
– If the speakers are facing a solid wall or glass
door, etc., it is recommended to furnish the wall
with materials that absorb sounds, for example
by hanging up thick curtains, to prevent
reflections and standing waves.
– Do not reproduce sounds at so high a volume that they are
distorted; otherwise, the speakers may be damaged by
internal heat buildup.
– When moving the speakers, do not pull the speaker cords;
otherwise, the speakers may fall over, causing damage or
injury.
Checking the supplied accessories
LVT1278-001A
[UJ]

Advertisement

loading

Summary of Contents for JVC SP-F508

  • Page 1 Especially be careful that children do not lean against them. Thank you for purchasing a JVC speaker system. If you have any questions, consult your JVC dealer. Warnings, Cautions and Others Precautions for daily use •...
  • Page 2 Attaching the base plate To prevent the speaker from falling over, be sure to attach the supplied base plate to each speaker. • Take care not to drop the base plate or speaker while assembling; otherwise, it may cause damage to the floor or injury.
  • Page 3: Specifications

    If the impedance of this speaker is out of the speaker impedance range indicated on the amplifier, you cannot connect this system to the amplifier. • The maximum power handling capacity of the SP-F508 is 100 W. Excessive input will result in abnormal noise and possible damage.
  • Page 4 © 2004 Victor Company of Japan, Limited 0704NSMMDWHCE...
  • Page 5: Unpacking The Speakers

    • Place a large, thick cloth on the floor where you unpack the speakers, so you can protect the floor and the speakers themselves. Take out the packing pad (with speaker cords and screws) on the top. Speaker cords and screws Take out the speaker grilles and base plates.

This manual is also suitable for:

Sp-f508ud