JVC WB-1540 Instruction Book page 9

Mounting the Housing to the Wall (continued)
Waterproofing
8.
4.
Screw (M3 x 12) x 4
Alarm/Communication Cable
LAN Cable (Male)
Coaxial
Video Cable
AC 24 V
Power Cable
8.
Hole
Waterproofing
T
Not in use on this system.
9.
T
DC 12 V Power Cable
7.
5.
Bind with insulating tape
Bind using a waterproof
(adhesive) tape
6.
4.
Open the cable connection cover
Use provided hexagon wrench to remove the 4 screws
(M3 x 12) from the cable connection cover to open it.
5.
Connect each cable
Connect the necessary cables.
NOTES:
● When connecting to TK-C625, ensure to bind connectors
of LAN cables that are not in use with an insulating tape
before using.
● Ensure to bind the DC 12 V Power Cable that is not in use
on this system with insulating tape.
6.
Bind cable using a waterproof tape
Upon connecting, ensure to perform waterproofing
procedures by binding the joint of each cable with a
waterproof (adhesive) tape.
CAUTION:
For safety reasons, turn on the power only upon connecting
all cables.
7.
Fasten the cables in the interior of the arm
When waterproofing is complete, insert the cables into the
upper interior of the arm and fasten using a tape.
CAUTION:
When inserting the cables, ensure that all cable connections
are above the cable connection cover (see dotted line in the
left diagram 7.).
Failure to do so may cause malfunctions due to penetration
of rain water.
8.
Cover the hole and the mounting side of
housing with waterproof seal.
After the cables have been connected, cover the holes
made in step 1. with waterproof seal. With the Cable
connection cover open, put your hand in and cover the
hole. Cover the mounting side of the housing with
waterproof seal.
NOTE:
Be sure to perform waterproofing. Seepage of rainwater may
result in malfunction.
9.
Close the cable connection cover
When cable connection is complete, close the cable
connection cover and fasten 4 screws (M3 x 12) removed
in step 4. using the provided hexagon wrench.
9