JVC TK-C655 Instructions Manual page 35

Flush Mounted Ceiling
Bracket attached to the
ceiling
Ceiling
Mount
Screws (For attaching the Ceiling Mount
to the Flush Mounted Ceiling Bracket)
Hook
MEMO
Both the Flush Mounted Ceiling Bracket and the safety wire should be insulated from the ceiling structure.
If the ceiling structure is made of a metallic material, inadequate insulation with the camera may produce noise in the video output.
Anchor bolt
4.
mount holes
5.
Locking
screw
6.
7.
Ceiling panel
8.
Connect cables to the Ceiling Mount.
☞
P. 14, "Connection Cables"
Attaching a safety wire to the Ceiling Mount.
Attach a safety wire to the Ceiling Mount and to the ceiling slab or
channel to prevent the unit from dropping. First attach the safety
wire to the Ceiling Mount by passing the wire through the safety
wire hole.
☞
1.
P. 16, step "Attaching a safety wire".
Attach the Ceiling Mount to the Flush Mounted Ceil-
ing Bracket.
• Attach the Ceiling Mount to the Flush Mounted Ceiling Bracket,
taking care not to catch the connection cables.
• Please use the four screws provided (M4 x 12 mm). If the screws
that have been removed in step
may not be installed properly and may fall.
• Attach so that the locking screw of the Ceiling Mount is positioned
below the anchor bolt mounting hole of the Flush Mounted Ceiling
Bracket.
Attach the camera to the Ceiling Mount.
☞
P. 16, "Attaching the Camera"
Attach the ceiling panel.
Attach the ceiling panel, provided with the Flush Mounted Ceiling
Bracket, by attaching the two hooks, one an each side.
2.
above are used, the camera
35