Table of Contents
Advertisement
G
Function selection switches
1.
[AGC] Auto-gain control switch.
Setting this switch to ON automatically
increases the sensitivity even when the
brightness of the subject is insufficient.
(Default setting: ON)
2.
[SELECT] WHT.BAL./PHASE setting switch.
WHT.BAL.:
The F [R/B,+/-] buttons are used as [R/B]
adjustment buttons.
PHASE:
The F [R/B,+/-] buttons are used as [+/-]
adjustment buttons.
(Default setting: WHT.BAL.)
3.
[SYNC] Synchronization system selection
switch.
This switch sets the synchronizing system for the
camera.
INT:
This is set for internal synchronization
LL (Line Lock):
The camera's vertical synchronization is locked
to the AC 24 V power line frequency. When
switching between multiple cameras using a
switcher, selecting this mode and adjusting the
vertical phase can reduce the monitor sync
disturbances occur that when the camera
image is switched.
U type: 60 Hz only
E type: 50 Hz only
(Default setting: INT)
4.
[WHT.BAL.] ATW/MANUAL selection switch.
For selecting whether to adjust the white
balance automatically or manually.
When the setting is changed from manual to
ATW, the setting values in the manual mode will
be reset. The camera switches to the same
mode as with pressing the [RESET] button.
(Default setting: ATW)
Note:
● The white balance of this camera is preset to
use under sunlight or halogen lamps, and
may not be properly adjusted when used
under artificial lights such as fluorescent
lights.
5.
[BLC] Backlight compensation switch.
When the object is placed against the light,
setting this to ON increases the iris aperture
by 1 stop and the object will appear brighter.
(Default setting: OFF)
6.
[DAY/NIGHT] Easy DAY & NIGHT switch.
To capture a subject with continually changing
brightness (day/night), set this switch to ON
The camera automatically captures the image in
color when the subject is bright, and in black and
white mode when it is dark.
(Default setting: OFF)
Note:
● When this item is set to ON , the AGC
feature will automatically be set to ON
regardless of the [AGC] Switch 1 setting.
● The Easy DAY & NIGHT feature on this
camera uses a sensitized black and white
mode unlike other black and white
surveillance cameras that use infra-red
lighting.
● Sensitivity increases in the case of black-and-
white images. The screen may therefore
appear rougher and white spots may
increase.
7.
[ALARM] alarm input mode selection
switch.
For setting the lens movement when there is an
alarm input. Set according to the alarm device
that you are using.
(A pg. 18 Electrical Specifications of Alarm
Input Terminals )
(A pg. 25 Adjusting the video image )
TRIGGER:
Upon input of an alarm, the lens moves to the
preset zoom/focus position (alarm position).
The lens remains in the alarm position for 15
seconds before it returns automatically to the
home position.
When there is a new alarm input while the lens
is at the alarm position, the lens continues to
remain in the alarm position for 15 seconds
upon the last alarm input.
STATE:
Upon input of an alarm, the lens moves to the
preset zoom/focus position (alarm position).
The lens remains in the alarm position for 15
seconds. The lens will, after a lapse of 15
seconds, continue shooting at the alarm
position as long as there is alarm input. The
lens returns automatically to the home position
immediately after alarm input stops.
(Default setting: TRIGGER)
8.
[RESET/SPOT] RESET/SPOT correction
selection switch.
RESET:
The [RESET/SPOT] button E is used as a
[RESET] button.
SPOT:
The [RESET/SPOT] button E is used as a
[SPOT] button. (A Pg. 34)
(Default setting: RESET)
Advertisement
Table of Contents
