JVC TK-C215VP12U/E Instructions Manual page 11

Camera (Interior)
M
N
O
P
Q
R
S
T
*TK-C215VP4U/E is used in the above illustration
M
Rotation Knob ( TK-C215VP4U/E only)
Rotate the lens unit to adjust the inclination of
the image. (A Pg. 25)
N
Rotation Center Mark
(A Pg. 25)
O
Fall Prevention Wire
Use this to connect the base G to the dome
cover D.
P
Camera Unit Fastening Screw
Use this to fasten the camera body R to the
base G.
To remove (A Pg. 21)
Q
[MONITOR]Monitor Terminal (RCA Jack)
(A Pg. 25)
R
Camera Unit
S
Connector for Power Supply of Heater
This is a power connector for use when the
heater (sold separately: KA-ZH215) is mounted.
T
Space for Heater
Memo:
● When mounting the heater (sold separately:
KA-ZH215), read the instruction manual of
the heater carefully before mounting.
Lens
(A next page)
U
Camera Unit Fastening Clip
This clip is used for fastening the camera unit to
the base. When removing the base, press
toward the direction indicated by the arrow to
release. (A Pg. 21)
V
Tilt Fastening Screw
Upon adjusting the angle of view, tighten the
screw to ensure that camera's angle of view
does not go out of alignment when it is used at a
location with strong vibration. (A Pg. 25)
2
W
Shooting Direction Mark
Install the camera by aligning the shooting
direction with the arrow mark.
X
Lug Plate
This plate is used for fastening the silica gel.
(A Pg. 24)
Y
Space for Silica Gel
(A Pg. 24)
Y
X
W
V
U
2