Starting & Stopping The Engine; Preparing To Drive - TATA Motors INDICA VISTA Owner's Manual

06
STARTING & DRIVING
STOPPING THE ENGINE:
Before switching off the engine, run the
engine in idle condition for at least 30
seconds and then switch off. This will
allow the engine oil to lubricate the
turbocharger, till its speed is fully
reduced and also allow the unit to cool
down.
The above precautions will ensure
satisfactory life and performance from
the turbocharger, till its speed is fully
reduced and also allow the unit to cool
down.
NOTE
If the engine fails to start, try to
restart the engine after few minutes.
Continuous cranking will cause
damage to the starter motor. If the
engine fails to start, Contact TATA
MOTORS Authorized Service
Centre.
90
STOPPING THE ENGINE, PREPARING TO DRIVE & GEAR LEVER

PREPARING TO DRIVE:

•
Release the parking brake.
•
Check that all items that you may
be carrying inside are fully secured.
•
Ensure that all doors are locked
properly
•
Check & adjust seat.
•
Fasten seat belt properly
•
Ensure that all gauges and
indicators lights are working.
•
Check for blind areas being
unobstructed in front and rear of the
vehicle.
•
Before driving off check in the rear
view mirror, for approaching traffic.
•
Switch on side indicator signal
when getting into main stream of
traffic.
GEAR LEVER AND SHIFTING:
The gearshift lever is mounted on the
center console between the two front
seats. The gearshift pattern is as
shown on the gear lever knob.
Application of Gear shifting should
always be done with clutch pedal
pressed.
NOTE
The reverse gear should be engaged
only when the vehicle is stationary.
Wait for 5 seconds after declutching
to ensure smooth engagement of
the reverse gear.