PAGE 59
Connecting Your Touch Panel
The ETP-1500 touch panel communicates with FireBall using a serial connection. You should use COM port 2 for the
Touch Panel.
Follow these steps to connect the ETP-1500 to your FireBall:
1. Put your FireBall into Standby mode by pressing the POWER button on the front panel until the
front panel display is off.
2. Connect your ETP-1500 to COM port 2 on the back of FireBall using the supplied serial cable.
3. Connect the supplied S-Video cable from one of FireBall's S-Video output jacks to the S-Video
input on bottom edge the ETP-1500 screen.
4. Connect the supplied power cable from the ETP-1500 to an AC outlet.
5. Power on your FireBall using the front panel POWER button.
FireBall will automatically recognize that an ETP-1500 is connected to COM port 2 and display the Touch Panel
Overlay buttons around the perimeter of the screen.