Honda Insight 2005 Reference Owner's Manual page 148

Main Menu Table of Contents
WEATHER SEAL BULB
CONNECTOR HOLD-DOWN WIRE
2. Remove the electrical connector
from the bulb by squeezing the
connector on both sides to unlock
the tab. Pull the connector straight
off.
3. Remove the rubber weather seal
by pulling on the tab.
Unclip the end of the hold-down
4.
wire from its slot. Pivot it out of
the way, and remove the bulb.
5. Insert the new bulb into the hole,
making sure the tabs are in their
slots. Pivot the hold-down wire
back in place, and clip the end into
the slot.
6. Install the rubber seal over the
back of the headlight assembly.
Make sure it is right side up; it is
marked ''TOP''.
Push the electrical connector onto
7.
the tabs of the new bulb. Make
sure it locks in place.
Turn on the headlights to test the
new bulb.
8. (Driver's side)
Reinstall the engine coolant
reserve tank.
Replacing a Front Parking Light
Bulb
Remove the socket from the
1.
headlight assembly by turning it
one-quarter turn counterclockwise.
2. Pull the bulb straight out of its
socket.
3. Install the new bulb into the
socket.
Lights
CONTINUED
147