Subaru 2003 Legacy Service Manual page 71

B: REPLACEMENT
1. EXCEPT 3.0 L MODEL
1) Remove V-belt cover.
NOTE:
Wipe off any oil or water on the belt and pulley.
2) Loosen the lock bolt (A).
3) Loosen the slider bolt (B).
4) Remove the front side belt (C).
( B )
( C )
5) Loosen the lock nut (A).
6) Loosen the through-bolt (B).
7) Remove the rear side belt (C).
( B )
( C )
8) Install a new belt, and tighten the through-bolt so
as to obtain the specified belt tension.
9) Tighten the lock nut (A).
Tightening torque:
22.6 N·m (2.3 kgf-m, 16.6 ft-lb)
( B )
( C )
10) Tighten the through-bolt (B).
Tightening torque:
8 N·m (0.8 kgf-m, 5.8 ft-lb)
DRIVE BELT(S)
( A )
PM-00116
( A )
PM-00117
( A )
PM-00117
PERIODIC MAINTENANCE SERVICES
11) Install a new belt, and tighten the slider bolt so
as to obtain the specified belt tension.
12) Tighten the lock bolt (A).
13) Tighten the slider bolt (B).
Tightening torque:
Lock bolt:
25 N·m (2.5 kgf-m, 18 ft-lb)
Slider-bolt:
8 N·m (0.8 kgf-m, 5.8 ft-lb)
( C )
14) Install V-belt cover.
2. 3.0 L MODEL
1) Fit the tool to the belt tensioner mounting bolt.
2) Turn the tool clockwise, and loosen the V-belt to
remove.
PM-13
( B )
( A )
PM-00116
PM-00118