Subaru 2003 Legacy Service Manual page 55

20. FRONT HOOD LATCH CHECK
Retract the front hood stay and close the hood.
Check that the front hood is securely latched.
21. KEYLESS ENTRY SYSTEM
Check the keyless entry system operations as fol-
lows.
• Remove the key from the ignition switch and
close all the doors including rear gate (wagon).
• Press the "LOCK" button on the transmitter mo-
mentarily once and check if all the doors are locked
and the hazard light flashes ones.
• Press the "OPEN" button on the transmitter mo-
mentarily once and check if the driver's door is un-
locked, the hazard light flashes twice and the dome
light illuminates.
• Close all doors and rear gate, press the "LOCK"
button of the transmitter. Press the "OPEN" button
of the transmitter and wait for 30 seconds. Check
that all doors and the rear gate are automatically
locked again.
22. SEAT
Check that each seat provides full functionality in
sliding and reclining. Check all available functions
of the rear seat such as a trunk-through center arm
rest.
23. SEAT BELT
Pull out the seat belt and then release it. Check that
the belt webbing retracts smoothly.
PRE-DELIVERY INSPECTION
PI-00117
PI-00118
PI-9
24. WHEEL ALIGNMENT
Check the wheel alignments. <Ref. to FS-6, Wheel
Alignment.> and <Ref. to RS-8, Wheel Align-
ment.>
25. TEST MODE CONNECTOR
Turn the ignition switch to ON and check that the
check-engine light starts blinking. If the light blinks,
return the ignition key to LOCK and disconnect the
test mode connector. Then, turn the ignition key to
ON again. If the check-engine light blinks at that
time in spite of the disconnected test mode connec-
tor, carry out an engine diagnosis.
With OBD model
(A) Test mode connector (Green)
Without OBD model
(A) Test mode connector (Green)
(B) Lead memory connector (Black)
PRE-DELIVERY INSPECTION
( A )
PI-00119
( B )
( A )
PI-00120