Subaru 2003 Legacy Service Manual page 49

B: PDI PROCEDURE
Follow the procedures shown in the table below.
Static Checks Just After Vehicle Receipt
Step
1. Appearance check
2. Tire check
3. Fuse installation
4. Connection of air conditioner cut connector
5. Check the doors for lock/unlock and open/close
operations.
6. Operation check of child lock system
7. Check the trunk lid open/close operations.
8. Check the rear gate for lock/unlock and open/
close operations.
9. Operation check of fuel lid opener lock release
lever
10. Accessory check
11. Operation check of hood lock release system
12. Battery
13. Brake fluid
14. Engine oil
15. Transmission fluid
16. AT front differential oil
17. Coolant
18. Clutch fluid
19. Window washer fluid
20. Hood latch check
21. Keyless entry system
22. Seat
23. Seat belt
24. Wheel alignment
PRE-DELIVERY INSPECTION
(1) If the vehicle is covered with protective film, visually check the vehicle
body for damage and dents.
(2) If the protective film has been removed, visually check the body paints for
small areas of damage or stains.
(3) Visually check the glass and light lenses for any damage and cracks or
excessive gaps to the body sheet metal.
(4) Visually check the plated parts for any damage.
(1) Check the tires for damage, abnormal conditions, and dents on the
wheels.
(2) Check the tire air pressure.
(1) If the vehicle is about to be delivered to the customer, attach a fuse.
(1) If the vehicle is about to be delivered to the customer, connect air condi-
tioner cut connector or air conditioner harness.
(1) Using the key, check if the door can be locked and unlocked normally.
(2) Open and close the all doors to see that there are no abnormal condi-
tions.
(1) Inspect whether child lock system operates properly.
(1) Operate the trunk lock release lever to check that the trunk opens nor-
mally.
(2) Using the key, check if the trunk lid can be unlocked normally.
(3) Open and close the trunk lid to see that there are no abnormal conditions.
(1) Using the key, check if the rear gate can be lock and unlocked normally.
(2) Open and close the rear gate to see that there are no abnormal condi-
tions.
(3) Operate the power door locking switch to check that the rear gate is
locked and unlocked normally.
(1) Operate the fuel lid opener to check that the fuel lid is unlocked normally.
Check the following accessories are provided:
• Owner's manual
• Warranty booklet
• Service booklet
• Spare key
• Jack
• Tool set
• Spare tire
(1) Operate the hood lock release lever to check that the hood opens nor-
mally.
(1) Check the battery for any abnormal conditions such as rust and trace of
battery fluid leaks.
(1) Check the fluid amount.
(1) Check the oil amount.
(1) Check the fluid amount.
(1) Check the AT front differential oil amount.
(1) Check the coolant amount.
(1) Check the clutch fluid amount.
(1) Check the window washer fluid amount.
(1) Check that the front hood is closed and latched securely.
(1) Check that the keyless entry system operates normally.
(1) Check the seat surfaces for smears or dirt.
(2) Check the seat installation conditions and functionality.
(1) Check the seat belt installation conditions and functionality.
(1) Check that the wheel alignments are properly adjusted.
PI-3
PRE-DELIVERY INSPECTION
Check point