Subaru 2003 Legacy Service Manual page 70

PERIODIC MAINTENANCE SERVICES
6. Drive Belt(s)
A: INSPECTION
1. EXCEPT 3.0 L MODEL
1) Replace belts, if cracks, fraying or wear is found.
2) Check drive belt tension and adjust it if neces-
sary by changing generator installing position and/
or idler pulley installing position.
Belt tension
(A)
replaced: 7.0 — 9.0 mm (0.276 — 0.354 in)
reused: 9.0 — 11.0 mm (0.354 — 0.433 in)
(B)*
replaced: 7.5 — 8.5 mm (0.295 — 0.335 in)
reused: 9.0 — 10.0 mm (0.354 — 0.394 in)
*: There is no belt (B) on models without an air con-
ditioner.
GEN
P/S
C/P Crankshaft pulley
GEN Generator
P/S Power steering oil pump pulley
A/C Air conditioning compressor pulley
I/P Idler pulley
DRIVE BELT(S)
98 N (10 kg, 22 lb)
A/C
( A ) ( B )
I/P
C/P
PM-00113
2. 3.0 L MODEL
1) Replace belts, if cracks, fraying or wear is found.
2) Check that the V-belt automatic tensioner indica-
tor is within the range (D).
( C )
(A) Indicator
(B) Generator
(C) Power steering oil pump
(D) Service limit
PM-12
( A )
( D )
( B )
PM-00114