Table of Contents
Advertisement
Controls and Features (cont.)
Control Panel (Cont.)
1 2
STAND BY
7
AV button
Use this button to select a device such as a video deck
connected to the EXT. IN terminal of the projector. Each
time you press the button, the device selected changes as
follows:
*
Y/C
* Y/C and VIDEO can be used only when a video board
separately sold has been installed.
8
RGB button
Use this button to select a device connected to the RGB
-1 or -2 terminals. Each time you press the button, the
selection changes as follows:
RGB 1
9
SETTING button
Use this button to call up the setting menu. For details,
refer to "Making Basic Settings" on page 30.
3 4 5 6
TEMP
OPERATE
LAMP
EMERGENCY
*
VIDEO
YPBPR
RGB 2
7
8
9
AV
RGB
SETTING
QUICK
ALIGN.
p
QUICK ALIGN. button
While a menu screen is shown, use this button to adjust
the values for the item selected. When no menu is shown,
the quick alignment function works.
• When a menu is shown
button: The value for the selected item increases.
button: The value for the selected item decreases.
• When no menu is shown
Press the
button and
QUICK-ALIGNMENT is displayed on the screen and the
quick alignment function works (TRACKING, PHASE, H.
POS. and V. POS. are automatically adjusted). When the
adjustment is finished, the display goes off automatically.
Memo
The quick alignment function :
• Works for computer input (RGB- 1 and - 2 input terminals) signals.
• Does not work for video input (EXT. IN input terminal) signals.
CAUTION
• Automatic adjustment with the quick alignment function
should be done on a bright still-picture screen. This function
may not work correctly on a dark screen or motion-picture
screen. If adjustment with this function is not satisfactory,
adjust TRACKING, PHASE, H. POS. and V. POS. manually
(see pages 30, 36 and 37).
p
button at the same time:
9
Advertisement
Table of Contents
