Table of Contents
Advertisement
Troubleshooting (Cont.)
Symptom
Lens shift adjustment
• Is the shift center lock pin for shipment
is not possible.
Remote control unit
• Are batteries installed correctly?
does not work.
• Are batteries exhausted?
• Is there a shielding object between the
• Is the distance too long?
• Is the remote control's LENS
When the emergency indicator starts blinking:
Refer to the CAUTION and NOTES on page 24.
* This projector is equipped with a microcomputer that may operate abnormally due to interference from external components.
If this happens, turn off the main power and disconnect the power cord from the wall AC outlet. Then reconnect the power cord
to AC outlet and turn on the main power again.
(For the turning on and off the power, see pages 25)
Probable cause
left attached?
remote control unit and the remote
sensor?
LOCKÔUNLOCK switch set to LOCK?
Corrective action
• Remove the shift center lock pin, and
then make adjustments. (For how to
remove the shift center lock pin,
consult the dealer where you
purchased the projector or a local
service center.)
• Match the polarities of batteries
correctly (+ to + and - to -).
• Replace with new batteries.
• Remove any shielding objects.
• Use the remote control unit at a nearer
point.
• Set the remote control's LENS
LOCKÔUNLOCK switch to UNLOCK?
Page
16
13
13
––––
22
12
63
Advertisement
Table of Contents
